Component Solution Services REC02F Servisní příručka stáhnout pdf (Strana 94)

Ultraview 1030/1050 Monitors — Service Manual

5-6

For detailed information on the extended diagnostics and how to run them, refer to Diagnostic

Menus on page 5-6.

Diagnostic Menus

Touch the D key in the Boot menu to display the Main Diagnostic menu:

Figure 5-4: Main Diagnostic menu

The following functions are available in this menu:

r — returns to the Boot menu.

a — runs all the diagnostics that are marked with an asterisk in the individual diagnostics

submenus; these tests are identical to the power-ON diagnostic tests; alternate CPU and

DRAM tests are available in the submenus.

i — displays the individual diagnostic submenu (described in detail below).

l — toggles Loop mode ON or OFF; when Loop mode is ON, any test or tests that are selected

will run in a continuous loop until power is cycled.

h — toggles Halt On Error mode ON or OFF; when ON, any failure that occurs while tests are

running in Loop mode immediately stops testing.

s — shows system information, including details of address spaces and variables used in the

system.

R — Causes a cold boot reset just like cycling power.

MAIN DIAGNOSTIC MENU

a - Run all diagnostics marked with “*”

i - Run an individual diagnostic...

l - Toggle “Loop Mode” ON/OFF

h - Toggle “Halt On Error Mode” ON/OFF

s - Show system info

R - Reset monitor (cold boot)

r - Return to boot menu

ai lhsR

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 141 142

Žádné komentáře

Component Solution Services REC02F Servisní příručka Strana 94